Density altitude is the altitude in the standard atmosphere where the air is as dense as the air around you. On a hot day at a high site it can be far above the real elevation, and wings and engines then perform as if they were that high.

Without a dew point, the calculator uses dry air. Humidity raises the density altitude a little.

–density altitude
  • Pressure altitude–
  • Standard temperature at that altitude–
  • Your temperature is–
  • Air density–
  • Compared with standard sea level–
  • True airspeed at the same indicated airspeed–
  • Power of a normally aspirated engine–

The calculation runs in your browser. Nothing you enter is sent anywhere.

Pressure altitude and density altitude

Pressure altitude is what your altimeter reads when it is set to 1013.25 hPa (29.92 inHg): the altitude in the standard atmosphere that has the same pressure. It differs from the real elevation whenever the pressure is above or below standard.

Density altitude corrects the pressure altitude for temperature. The standard atmosphere is 15 °C at sea level and cools by about 2 °C per 1,000 ft (6.5 °C per 1,000 m). Air warmer than that is less dense, so the density altitude is higher. The FAA's rule of thumb adds about 120 ft for each °C above the standard temperature.

Say you take off from 2,000 m on a 25 °C afternoon, with a QNH of 1013 hPa. The standard temperature at 2,000 m is 2 °C, so the air is 23 °C warmer than standard, and the density altitude is about 2,790 m (9,170 ft).

What it changes for your flight

Lift, engine power and propeller thrust all depend on the density of the air. When the density altitude is high:

  • Paragliders and hang gliders need more true airspeed to fly. At the same indicated airspeed the wing moves faster through the thin air, so the take-off run is longer and faster, and you land faster over the ground.
  • Paramotors, trikes and ultralights lose engine power and thrust. The take-off run gets longer and the climb weaker.
  • Hot air balloons get less lift from the same envelope temperature, so they can carry less.
  • Aeroplanes need a longer take-off run and climb more slowly.

The calculator shows how much faster your true airspeed is than at standard sea level, and how much power a normally aspirated piston engine keeps, with the Gagg-Farrar estimate. Turbocharged engines and electric motors behave differently.

How the calculator works

It follows the method of the US National Weather Service. From the elevation and the altimeter setting it works out the pressure at the site. From that pressure, the temperature and, if you enter it, the dew point, it works out the density of the air. The density altitude is the altitude where the standard atmosphere has that density.

Humidity makes the air slightly lighter, because water vapour is lighter than dry air. The effect is small: at 1,500 m and 30 °C, a dew point of 20 °C adds about 100 m (340 ft).

Questions

What is the formula for density altitude?

The quick estimate is pressure altitude + 120 ft × (outside temperature − standard temperature), with temperatures in °C. The calculator uses the National Weather Service method, which is more exact and includes humidity.

Is density altitude the same as pressure altitude?

Only at the standard temperature. Pressure altitude corrects the elevation for the air pressure; density altitude then corrects it for temperature and humidity.

What is a high density altitude?

There is no fixed limit. What matters is how far it is above the elevations you usually fly from: on a hot day, a site at 1,500 m can behave like one at 2,500 m.

Where do I find the altimeter setting (QNH)?

Airport METAR reports and aviation weather sites give it. Without one, the sea-level pressure in a weather forecast is close enough for this calculation.

More tools for pilots

Sources

Get Wingman

Free to download on the App Store, for iPhone and Apple Watch. Wingman PRO is optional.

Wingman on the App Store